Wed, May 27
Mon, May 25
Can target multiple directories now
Sat, May 23
I could make it so a 40pin IDE cable could be used to connect it to another board for MITM, would make it a bit easier to use for that. It'll make the silk screen a little more complicated but it shouldn't be too bad. I probably should make it so a logic analyzer can be attached to both the console and controller side as well.
V2 is done and works but it's upside down to what I had intended, oops.
So for V3:
- Flip it
- Make it easier to connect to another board?
Fri, May 22
Sun, May 17
Wed, May 13
Mon, May 11
Apr 27 2020
I'm pretty sure that this is a probing issue when it comes to my specific oscilloscope/probe setup. So I'll need someone with a better oscilloscope to check it out. However it may still be a good idea to at least buffer the CD_CLK. Even though we don't need the fanout something like the PL133-37TC would work well. It's cheap and small, which is important since there isn't much room to squeeze in something for the CD_CLK.